Acronis Drive Monitor - User Guide Manual de usuario descargar pdf (Pagina 13)

Attribute ID S.M.A.R.T. attribute

01 Raw Read Error Rate

02 Throughput Performance

03 Spin Up Time

04 Start/Stop Count

07 Seek Error Rate

08 Seek Time Performance

09 Power-On Time Count

12 Drive Power Cycle Count

221 G-sense Error Rate

228 Power off Retract Cycle

225 Load/Unload Cycle Count

194 Disk Temperature

199 Ultra ATA CRC Error Count

193 Load/Unload Retry Count

What else may decrease a disk's health?

When a disk is monitored using a custom script:

 exit code is 0 : Health = (disk health calculated by S.M.A.R.T.) * 100%

 exit code is 1 (warning) : Health = (disk health calculated by S.M.A.R.T.) * 50%

 exit code is 2+ : Health = 0%

Factors not affecting a disk health

 Decreasing value of a non-critical parameter does not affect the disk health till it is above a

threshold, specified by the disk's manufacturer;

 Event log entries also do not change the overall disk health, but still can generate Warnings or

Errors.

3.2.5 Using custom script

If any of your hard drives does not support S.M.A.R.T. for monitoring, you can create a custom script.

Each hard disk needs a separate custom script. On an Options (p. 21) page you may select a required

script for a drive in a Disk monitoring (p. 24) section.

The executable's output will be returned through the exit code and recorded to the respective log

entry.

Executed custom script provides a report about disk status:

0 - there are no errors and warnings, the disk is healthy;

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Sin comentarios

Acronis Drive Monitor - User Guide Manual de usuario Pagina 13