ACRONIS BACKUP RECOVERY 10 SERVER FOR LINUX - COMMAND LINE Manual de usuario descargar pdf (Pagina 7)

This chapter describes how to install the ATIS management module on a server where

Parallels Plesk Panel is installed.

In this chapter:

Installation Requirements .................................................................................. 7

Installing ATIS Management Module ................................................................. 8

Installation Requirements

For normal operation of the ATIS module, your server must meet the following

hardware and software requirements:

 Parallels Plesk Panel version 8.0 or later

Acronis True Image Server for Linux version 8.0 or later, installed on the same server

where Parallels Plesk Panel is installed

 3 MB of disk space available

 One of the operating systems supported by Acronis True Image Server for Linux

Note: You must install and configure Acronis True Image Server independently of the

Parallels Plesk Panel-integrated management module. You must also have a valid

license key for the ATIS application. You can purchase and install this license key

through Parallels Plesk Panel (Server > License Management > Order Control Panel Add-

ons). If Acronis True Image Server for Linux is not installed on your Parallels Plesk

Panel-enabled server, you can still install the ATIS management module but cannot

use it.

Important:

 The ATIS management module and Acronis True Image Server application cannot

be used in Virtuozzo virtual environments.

 The ATIS management module does not run under the FreeBSD operating system

because the Acronis True Image Server application does not support FreeBSD.

C H A P T E R 1

Installing ATIS Management Module

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Sin comentarios

ACRONIS BACKUP RECOVERY 10 SERVER FOR LINUX - COMMAND LINE Manual de usuario Pagina 7